Blog

25 September

“The Skinny on Thin Tiles”


“One of the hottest trends seen at the Cersaie show in Italy and Cevisama in Spain is the emergence of thin tiles. These thin tiles start at thicknesses of about 2.5 mm for walls up to about 6 mm thick for floors. Manufacturers tout a range of advantages, including installation over existing floor or wall coverings, eliminating the need for ripping out existing finishing materials in renovation projects, saving time and money in labor costs. The tiles are strong and lightweight, and reduce material consumption which benefits the environment. They can also be easily cut with a wet saw, and in some cases (easier with non-reinforced slabs) with a glass cutter…”

“…Here are some of the important factors Astrachan said must be considered in thin-tile installation:…”

“…For setting floor tiles, Astrachan observed a practice which goes against the grain of traditional tile installation: walking on the tile to embed it into the mortar. “This tile is flexible…stepping on it pushes it into place.” Not so much for beating the tile into the mortar with a rubber hammer, which can lead to breakage.

Astrachan stressed the importance of leveling the floor first, since mortar can’t be used to build up irregularities in the subfloor beneath – and Woelfel cautioned contractors to fully level the substrate and ensure flatness. “It’s like setting vinyl tile on walls,” Woelfel said. “It will telescope anything beneath it.” Woefel recommended the tile contractor conduct taping of drywall; in some cases, the wall may need to be mudded for a flat surface…”

 

 

Click the link below for the full article about this  trend!

 

“The Skinny on Thin Tiles”

 

Tile Letter Magazine

November 22, 2011

By: Tile Letter

 

 

 http://www.tileletter.com/2011/11/the-skinny-on-thin-tiles/


Leave a Comment